D3PE Builds Another Beast… The PumpKing

Brent Davis
January 30, 2015

The video was produced by D3 Performance Engineering out of Houston, TX and as awesome as this car is, we’re never that surprised to find out D3PE has built another amazing Corvette. This brilliant orange C6 is owned by William George, who chose to name this beast “The PumpKing.”

The PumpKing's Gold

ProCharger F1X Supercharger

A&A 10 Rib belt drive system

D3PE PROSPEED Air to water system

D3PE Gangsta lean cooling system

D3PE Race catch can system

D3PE C6 Corvette ProEFI package

D3PE Boost control system

H Squared Race Engines Ultra Billet LSX Package

GTP ported MAST heads

RPM level 6 trans with Liberty face plated gears

Spec E trim clutch

D3PE calibrated Ignite E98 ProEFI tuneThis car sounds rather angry at idle, as they proceed to move it in and around the garage, but that’s only the beginning. As you’ve seen in the video, the car spits some serious fire during one of the dyno passes, only to be extinguished by an additional throttle blip. Now that should catch some of the competition’s attention!

We were able to speak with David Donnals of D3 Performance Engineering who explained, “The car essentially ran out of fuel system capacity, so we are going to add another pump along with larger injectors. We should be able to get into the 1500+ rwhp area on boost alone, then we have a two-stage Nitrous Express system that we will let loose with a total of a 300-shot. We are currently prepping the car for the Texas Invitational roll race event and the TX2K15”

So for the math majors out there, you’ve already realized that when under a full nitrous load, this car will be producing close to 1,800 hp. Can you even imagine what that will feel like?

Screen Shot 2015-01-29 at 8.13.03 PM